Starting a Verify Manually

Verification of units can be done automatically, on a schedule, or can be started manually, as described below. (See Setting Auto Verify for a Unit and Scheduling Background Tasks.)


	Note: If the unit has not previously been initialized and you manually select Verify Unit in either 3BM or 3DM, the initialization process starts.

To verify a unit through 3DM

1	In 3DM, choose Management > Maintenance.

2	In the Unit Maintenance section of the Maintenance page, select the unit you want to verify and click Verify Unit.

3DM puts the selected unit in verifying mode. If verify scheduling is not enabled on the Scheduling page, the verification process begins almost immediately. If verify scheduling is enabled, the unit will not start actively verifying until the next scheduled time.

A Stop Verify link appears next to the unit on the Maintenance page. If you need to stop the verify process, use this link. (If initialization starts because the unit had not previously been initialized, it cannot be halted, so no Stop Verify link appears.)

Related Topics: About Verification